Ford Edge (2010) Suspension Recall: Incorrect Wheel Installation Risk
Bearing Technologies recalls certain 2007-2010 Ford Edge wheel spindles with oversized shoulder studs that may cause wheel vibration or wobble, increasing crash risk. Owners can get free repairs.
Use caution until it’s fixed
If the wheel is installed incorrectly, the wheel may vibrate or wobble, increasing the risk of a crash.
What happened, in plain English
Bearing Technologies is recalling certain 2007-2010 Ford Edge vehicles with defective wheel spindles that can cause wheel vibration or wobble if installed incorrectly. This increases the risk of a crash, so owners should contact the manufacturer for free repairs. Read more at govinfonow.com/recall/1253300-ford-edge-2010-suspension-recall-incorrect-wheel-installation-risk.
Source Summary by GovInfoNow · govinfonow.com/recall/1253300-ford-edge-2010-suspension-recall-incorrect-wheel-installation-risk · Updated October 7, 2026 · Official notice: NHTSA #17E053000
Cite this page
“Ford Edge (2010) Suspension Recall: Incorrect Wheel Installation Risk.” GovInfoNow, updated October 7, 2026. https://govinfonow.com/recall/1253300-ford-edge-2010-suspension-recall-incorrect-wheel-installation-risk. Based on NHTSA recall #17E053000 (https://www.nhtsa.gov/recalls?nhtsaId=17E053000).
Why it’s dangerous
The wheel spindles have an oversized shoulder on the mounting studs that can prevent proper installation. If installed incorrectly, the wheel may vibrate or wobble, increasing the risk of a crash.
Who’s affected
Owners of 2007-2010 Ford Edge vehicles with the specific Duralast wheel spindle part number DL930676K are affected. Drivers using these spindles are most at risk of wheel vibration or wobble.
How to tell if you have this one
Check for the Duralast wheel spindle part number DL930676K on your 2007-2010 Ford Edge vehicle. The affected spindles have wheel mounting studs with an oversized shoulder.
- Brand
Bearing- Category
Vehicle
What to do — step by step
Contact Manufacturer
Call Bearing Technologies at 1-800-597-3486 or visit www.recall17E053.com to get free repairs for the defective spindle.
What NHTSA says to do
Bearing will notify the distributors of the spindles. If the studs on a defective spindle are not loose, Bearing will replace the studs at no charge. If the studs on a defective spindle are loose, Bearing will replace the spindle assembly at no charge. Bearing will also pay shop labor for the remedy. The recall began on October 16, 2017. Owners may contact Bearing Technologies customer service at 1-800-597-3486 or visit www.recall17E053.com.
Keep exploring
Where this comes from
The facts (hazard, remedy, dates, manufacturer) are pulled from the official NHTSA recall record. The plain-language summary and step-by-step checklist are written by GovInfoNow to make the official notice easier to act on — they don’t replace it.
- Official source: NHTSA Recall #17E053000 (September 27, 2017)
- Plain-language summary written by qwen3:4b on October 7, 2026, from the official record above. Not reviewed by a person — if it conflicts with the NHTSA notice, the notice is correct. Report an error on this page.
- GovInfoNow is an independent service and is not a government agency. We republish official NHTSA recall data; we don’t issue, amend or administer recalls.