2012 Mci D4000 recalls (2)
2 NHTSA safety recalls cover the 2012 Mci D4000. Every recall repair is free at any Mci dealer.
Is yours affected? Recalls cover ranges of VINs, not every 2012 Mci D4000. Check your D4000 by VIN and confirm open recalls at NHTSA.gov.
Every 2012 Mci D4000 recall
Each campaign as NHTSA published it: what is wrong, what can happen, and the fix. Newest first.
Seats · NHTSA 16V020000
- Problem
- Motor Coach Industries (MCI) is recalling certain model year 2011-2013 and 2015 J4500 coaches manufactured November 18, 2011, to July 10, 2015, 2011-2012 and 2014-2015 D4000 coaches manufactured manufactured September 24, 2010, to September 5, 2015, 2011-2013 and 2015-2016 D4005 coaches manufactured January 17, 2011, to November 23, 2015, 2012-2014 and 2016 D4000ISTV coaches manufactured July 18, 2012, to December 2, 2015, 2010-2016 D4500 coaches manufactured April 15, 2010, to December 18, 2015 and 2011-2016 D4505 coaches manufactured December 15, 2010, to December 4, 2015. The affected buses are equipped with certain Recaro Ergo-M Commercial Bus Driver Seats that have J-Brackets that may be missing welds which could allow the seat belt anchorage assembly to separate from the J-Bracket.
- Risk
- If the seatbelt anchorage assembly separates from the J-Bracket, the bus driver may not be properly restrained in the event of a crash increasing their risk of injury.
- Fix
- MCI will notify owners and dealers will inspect the seats and determined if welds are missing. Any J-Bracket that is missing welds will be removed and replaced, free of charge. The recall began on February 15, 2016. Owners may contact MCI at 1-800-241-2947. MCI's number for this recall is SB 431.
Electronic Stability Control (Esc) · NHTSA 11V524000
- Problem
- MOTOR COACH INDUSTRIES (MCI) IS RECALLING CERTAIN MODEL YEAR 2003, AND 2007-2012 E AND J MODELS ALONG WITH MODEL YEAR 2007-2012 D4000, D4005, D4500, D4505, D4000ISTV MOTOR COACHES EQUIPPED WITH MERITOR WABCO ELECTRONIC STABILITY CONTROL (ESC) MODULES, MANUFACTURED FROM OCTOBER 2002, THROUGH OCTOBER 2011. UNDER CERTAIN ROAD AND DRIVING CONDITIONS, VEHICLE BODY ROLL AND ROAD INCLINATION CHARACTERISTICS MAY ADVERSELY AFFECT THE SLIP ANGLE CALCULATION OF THE ELECTRONIC STABILITY CONTROL (ESC) SYSTEM. THIS MIGHT CAUSE THE ESC TO PERCEIVE AN OVER STEERING SITUATION AND THEREFORE APPLY THE OUTER WHEEL BRAKE ON THE FRONT AXLE UNTIL THE VEHICLE IS PERCEIVED TO BE STABLE.
- Risk
- IF THE DRIVER IS SLOW TO REACT DURING THIS ESC INTERVENTION, THE VEHICLE MAY DEVIATE FROM THE INTENDED LINE OF TRAVEL, INCREASING THE RISK OF A CRASH.
- Fix
- MCI WILL NOTIFY OWNERS AND REPLACE THE CONTROL MODULE FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 4, 2012. OWNERS MAY CONTACT MCI CUSTOMER SERVICE AT 1-800-241-2947.
2012 Mci D4000 complaints and service bulletins
Mci has issued at least 17 technical service bulletins (repair instructions to dealers) for this model year. Complaints are unverified owner reports; a recall is the manufacturer’s admission of a safety defect.
Service bulletins by component
- Engine (3)
- Engine and Engine Cooling (3)
- Power Train (3)
- Electrical System (2)
- Equipment (1)
- Equipment Adaptive/Mobility (1)
NHTSA defect investigations covering the 2012 Mci D4000
NHTSA’s Office of Defects Investigation lists this model year in 3 investigations. An investigation is not a recall; it is how NHTSA decides whether one is needed.
- Exhaust Bellows Pipe Fracture Recall
- MCI Drive Shaft Safety Loop Failures
- MCI Driveshaft Safety Loop Failures
Check your D4000 by VIN
Not every 2012 Mci D4000 is in every recall. Enter your 17-character VIN to see the recalls on record for your exact vehicle, then confirm which are still open at NHTSA.gov or with any Mci dealer.