What Chrysler Sebring owners have reported to NHTSA, the service bulletins the manufacturer sent dealers, and any federal defect investigations, by model year. See Chrysler Sebring safety recalls or check your VIN.
Complaints owners filed with NHTSA, by the model year of the vehicle. A high count can also mean a popular year, so compare it with how many were sold.
| Year | Complaints | Crashes | Fires | Injured | Deaths | TSBs |
|---|---|---|---|---|---|---|
| 2013 | 0 | 0 | 0 | 0 | 0 | 97 |
| 2012 | 0 | 0 | 0 | 0 | 0 | 88 |
| 2011 | 3 | 0 | 0 | 0 | 0 | 76 |
| 2010 | 104 | 8 | 5 | 3 | 0 | 60 |
The vehicle systems named most often in Chrysler Sebring complaints (one complaint can name several).
In the owners’ own words, as filed with NHTSA. Unverified reports; NHTSA removes personal details before publishing.
tHE HORN IS NOT WORKING AND THE AIRBAG LIGHT IS ON, DIAGNOSED AS BROKEN CLOCKSPRING.
On 6/22/24 I made a left turn, stopped to park. I shifted the gear into reverse and heard a loud pop sound then smoke start coming from underneath the driver side of the hood. I put the car into park and lifted the hood, there were flames on the driver side of the car. The fire department was contacted and put the fire out. The car is totaled.
The steering wheel got stiff and hard to turn making turning a struggle. The shifting gears slipped and locked in place. The electronic throttle is is indicating a problem. These are just a problem over some time.
The contact owns a 2010 Chrysler Sebring. The contact stated that while the vehicle was idling, the air bag warning light illuminated. The vehicle was taken to the dealer however, the vehicle had not yet been diagnosed. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 85,000.
Air bag light stays on at all times and it put fear of safety issue is a wreck is to happen. Driver seatbelt light doesnât go off, itâs as though when putting the belt on even though itâs latched it isnât and causes the warning light to stay on.
The driver seat has a part that wears out and causes the power seat to move forward and backward on its slide track. eventually the part will fail and the seat will slide right into the steering wheel which will impact the drivers chest. The power seat has two acme threaded rods that drive the seat rails forward/ backwards to allow driver to adjust the seat. the acme rods drive a custom screw block to allow the motion. when in static position only the screw block holds the seat and stops it from moving forward and backward. from what i can observe the acme rod is case hardened but the screw block is not. the screw block seems to wear out prematurely after four years. if left unaddressed the…
The contact owns a 2010 Chrysler Sebring. The contact stated that while starting the vehicle, the air bag warning light was illuminated. The vehicle was taken to the dealer, and the dealer performed a recall repair under NHTSA Campaign Number: 16V668000 (Seat Belts, Air Bags). The dealer informed the contact that the recall was not related to the failure. The vehicle was then taken to an independent mechanic who diagnosed that an unknown part of the driver's side air bag needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 101,462.
MY SON WAS DRIVING FORWARD UP A HILL. WHILE DRIVING THE CAR STARTED ROLLING BACKWARDS WHILE IN DRIVE GEAR. THEN WHILE THE VEHICLE DECIDED TO ROLL BACKWARDS IN DRIVE GEAR HE WAS UNABLE TO STOP. SINCE MY SON WAS UNABLE TO STOP HE PUT THE CAR IN PARK THE VEHICLE STILL CONTINUE TO ROLL BACKWARDS. AS A RESULT MY SON JUMPED OUT OF THE VEHICLE AND THE VEHICLE ROLLED DOWN THE HILL AND HIT A TREE AND BOULDERS. HAD THE VEHICLE TOWED TO THE DEALERSHIP AND THEY FOUND NOTHING WRONG. HOWEVER A WITNESS SEEN WHAT WAS HAPPENING TO MY SON IN DISBELIEF. THIS VEHICLE IS VERY UNSAFE FOR ANYONE TO DRIVE,
Repair instructions and other communications the manufacturer sent dealers about known issues. A TSB is not a recall, and the repair is usually free only while the car is under warranty; ask your dealer for the bulletin number.
ACTUATOR - A/C AND HEATER
LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.
LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.
Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.
Connector kit Before ordering this connector repair kit 68018957A$, check it in the Mopar Connector Repair Kit Website to confirm part number and applicability. There is an error with the wiring diagrams in Service Library that is causing the incorrect repair kit part number to populate. Please use the Mopar Connector Repair Kit Website until this issue is resolved.
FCA Caribbean Warranty Bulletin ID-23-20 "Can / Am" Warranty Coverage - 594 / 595 / 596 WCC
Warranty Bulletin D-16-03 - "Can / Am" Warranty Coverage - 594 / 595 / 596 WCC (Rev. B)
Lubrication and Maintenance Fluids If MOPAR fluids and chemicals are not readily available, please review Service Library for specifications so a suitable alternative can be used
Water Quality When Mixed With Engine Coolant
wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK
Approved Use of Weld Through Primers This bulletin documents the FCA US LLC position regarding the use of weld through primer when using Squeeze Type Resistance Spot Welding (STRSW) and Gas Metal Arc Welding (GMAW) processes when welding steel body panels and structural components.
Approved Use of Weld Through Primers This bulletin documents the FCA US LLC position regarding the use of weld through primer when using Squeeze Type Resistance Spot Welding (STRSW) and Gas Metal Arc Welding (GMAW) processes when welding steel body panels and structural components.
Source: NHTSA Office of Defects Investigation public data (complaints, manufacturer communications, investigations), model years 2010 and later. Had a safety problem? Report it to NHTSA.
In complaints filed with NHTSA for model years 2010–2013, owners most often name: air bags, seat belts, electrical system. 107 complaints are on record.
No. A complaint is an unverified report from an owner. A technical service bulletin (TSB) is the manufacturer telling dealers how to fix a known issue; it is not a safety recall and is usually covered only under warranty. A recall is a formal safety action, and its repair is free.
File a vehicle safety complaint at NHTSA.gov. NHTSA reads every report, and patterns of complaints are what open defect investigations and, eventually, recalls.
