Smiths Medical recalls Medfusion Syringe Pump models 3500-500 v3-v6 due to potential force sensor calibration drift causing false alarms or delayed occlusion detection. Affected units sold before April 2022 may require attention.
A force sensor in the occlusion detector may drift out of calibration leading to increased occlusion detection times, false occlusion alarms, or a System Failure Alarm. If the force sensor calibration shift is large enough, the pump will display a System Failure Alarm (including Force Sensor BGND Test, Force Sensor Bridge Test, or Force Sensor Test). However, if the calibration shift is not large enough to trigger a System Failure Alarm, the threshold to detect an occlusion may increase, increasing the time to occlusion detection, or the threshold may decrease, leading to false occlusion alarms. Although shifts in the force sensor calibration may occur over time with any device, an increased potential for such shifts has been reported in devices produced before April 2022 due to mechanical interference between parts of the plunger head assembly. Out of an abundance of caution, we are notifying all customers of this potential issue.
Smiths Medical is recalling Medfusion Syringe Pump models 3500-500 versions 3 through 6 because a force sensor may drift out of calibration. This could cause false occlusion alarms or delay detecting blockages, potentially leading to unsafe conditions during medical treatments.
The force sensor in the occlusion detector may drift out of calibration over time, especially in pumps made before April 2022. This could cause the pump to either delay detecting blockages or trigger false alarms, which might lead to unsafe medication delivery situations.
Patients using the Medfusion Syringe Pump for medical treatments are most at risk. Healthcare providers who use these pumps for administering medications may also be affected.
Check for the Medfusion Syringe Pump model 3500-500 with versions 3 through 6. Units sold before April 2022 are most likely affected. All serial numbers are included in the recall.
Look for System Failure Alarms or Force Sensor Test messages on the pump display.
Reach out to Smiths Medical for guidance on potential fixes or replacements.
The force sensor in the occlusion detector may drift out of calibration, causing false alarms or delayed detection of blockages in pumps made before April 2022.
No, but you should check for System Failure Alarms or Force Sensor Test messages and contact Smiths Medical for guidance.
Check for System Failure Alarms or Force Sensor Test messages on the pump display, then contact Smiths Medical for further instructions.
We’ve drafted a message you can send Smiths Medical to request your refund or repair — edit it as you like.
Subject: Recall Z-0076-2024 — Smiths Medical Smiths Medical Hello, I own a Smiths Medical that is covered by recall Z-0076-2024 from Smiths Medical. I’m writing to arrange the remedy described in the recall (a refund, repair, or replacement as applicable). Could you please tell me the next steps to resolve this? Thank you.
Experiences, tips, and questions from readers. Every comment is reviewed before it appears.
No comments yet — be the first to share your experience.
The facts (hazard, remedy, dates, manufacturer) are pulled from the official FDA recall record. The plain-language summary and step-by-step checklist are written by GovInfoNow to make the official notice easier to act on — they don’t replace it.
