Cooper Lighting recalls commercial reflector assemblies with glass lens that can fall from fixtures, posing injury risk. Affected units include specific model numbers and those without barcoded stamps.
The reflector can fall out of its fixture to the ground, which could result in an injury hazard.
Cooper Lighting is recalling commercial reflector assemblies with glass lenses that can fall from light fixtures, potentially causing injury. This recall affects facilities using specific model numbers and units without barcoded stamps.
The reflector assembly can detach from its fixture and fall to the ground, creating a hazard that could cause injury. This risk occurs because the springs holding the reflector may fail, especially in commercial settings where fixtures are subject to movement.
Facilities with commercial lighting fixtures using the recalled reflectors, such as offices, schools, and shopping malls, are most at risk. Maintenance personnel are the primary users who need to check and address the issue.
Check for a barcoded stamp on the reflector's outside surface. If absent, the unit is part of this recall. The affected models include specific catalogue numbers like 7080*G and 7-inch reflectors with glass lens marked with "PDR" prefix.
Maintenance personnel should inspect all affected fixtures to ensure the reflector assembly is securely attached.
Take down any reflector units that lack a barcoded stamp on their exterior surface.
Reach out to Cooper Lighting for free replacement springs for the affected units.
Maintenance personnel in facilities with these fixtures should check them immediately, take down any units without a barcoded stamp and contact Cooper Lighting for free replacement springs.
The recall includes Portfolio 7-inch reflector assemblies with glass lens marked with catalogue numbers like 7080*G, 7081*G, and others listed in the record, but units with a barcoded stamp are not affected.
Check if the reflector has a barcoded stamp on its outside surface. If it lacks this stamp, it is part of the recall.
No, but maintenance personnel should check fixtures immediately and remove units without barcoded stamps to prevent injury risk.
We’ve drafted a message you can send Cooper Lighting to request your refund or repair — edit it as you like.
Subject: Recall 1055 — Cooper Lighting Portfolio 7-inch reflector assembly with glass lens Hello, I own a Portfolio 7-inch reflector assembly with glass lens that is covered by recall 1055 from Cooper Lighting. The official recall notice states: Maintenance personnel in facilities with these fixtures should check them immediately, take down any units without a barcoded stamp and contact Cooper Lighting for free replacement springs. I’m writing to arrange the remedy described in the recall (a refund, repair, or replacement as applicable). Could you please tell me the next steps to resolve this? Thank you.
Experiences, tips, and questions from readers. Every comment is reviewed before it appears.
No comments yet — be the first to share your experience.
The facts (hazard, remedy, dates, manufacturer) are pulled from the official CPSC recall record. The plain-language summary and step-by-step checklist are written by GovInfoNow to make the official notice easier to act on — they don’t replace it.
